If you are a Capture user, you don't have to visit the Console every time you need to change a setting. Several Capture settings can be updated directly through your Commerce account.
Jump to:
Updating Settings
- In the left menu panel, click Studio and then select Devices from the drop down menu.
- This is where your Capture Devices will be listed. If you do not see your device in the list, click the blue Sync Devices button at the top right of the window.
- Select the name of the device you wish to update. This opens the device page which lists the Configuration menu and provides live device information.
- Make your way through the Configuration options and select what is most suited for your workflow.
- On the right side of the Configuration menu, you will see the Capture Device status.
- Press the green Update button to save the changes.
Lock Settings
To help reduce the risk of configuration changes inadvertently removing the connected session/event, device settings will be locked when a job sheet is scanned.
Once the update is in place, Console will lock the options to configure a device, such as shot mode etc. After a device scans a job sheet barcode the device locks. You will have a tag warning appear briefly on the reader as well.
This locking is visible inside Console and all configuration options are not shown. Click the Unlock button to change the settings.
|
|
Note: After unlocking the operator must always re-scan the job sheet or re-add the event/session to the capture device in use. |
Currently, there are no major alerts in Commerce like there are in Console. However, the configuration options will be locked and any attempt to change them will incur an error message.
To remove the lock and make settings changes, either press the unlock button inside Console or by shutting down the device. When re-starting a device, always begin by scanning the job code again.